New packaging of a chip on a board by a unique printing method

1992 
Transfer molding is a typical method for packaging integrated circuits (ICs). Transfer molding is very difficult to do at heights less than 1 mm, and has a limited surface mounting area. Recent research of high density surface mounting for thinner and lighter weight packaging has progressed for both IC cards and liquid crystal displays (LCDs). However, the dispensing method has many problems, such as the height variations of the coating, difficulties of uniform spreading on large size ICs, and one-by-one encapsulation. A unique printing method is developed to solve such problems. Through this method it is possible to achieve a height less than 1 mm and a uniform thickness on an integrated system. On reaching these parameters, the surface mount ICs replace molded packaged devices that are manufactured using expensive equipment and molding dies. The method requires only a small amount of epoxy resin and is, therefore, more economical than the conventional transfer molding process. A one-component epoxy resin NPR-150 suitable for printing is developed. >
    • Correction
    • Source
    • Cite
    • Save
    • Machine Reading By IdeaReader
    2
    References
    13
    Citations
    NaN
    KQI
    []