Peel Bond Strength between 3D-printing Tray Materials and Elastomeric Impression/Adhesive Systems: A Laboratory Study

Abstract Objectives The present study aimed to evaluate the bonding between three 3D printed custom tray materials and three elastomeric impression/adhesive systems using the peel test. Methods Test blocks were 3D printed by three different technologies using Dental LT, FREEPRINT tray, and polylactide (PLA) tray materials. The reference test blocks were conventionally fabricated with Zeta Tray LC, a light-curing resin. The surface topographies of the four tray materials were investigated by scanning electron microscopy (SEM) analyses and roughness measurements. The peel bond strength between the four tray materials and three impression/adhesive systems, vinylsiloxanether (VSXE), vinyl polysiloxane (VPS), and polyether (PE), was measured (n = 12 per group). The peeling failure modes and rupture sites were identified microscopically. Results The four tray materials featured different surface topographies. The peel bond strength was not significantly different with VSXE and PE, but PLA and the reference showed higher peel bond strength with VPS than the Dental LT and FREEPRINT tray (p  Significance The 3D printed tray materials can achieve satisfactory chemical compatibility with the adhesives of VSXE, VPS, and PE. Surface topographies generated by the 3D printing technologies may affect bonding. Generally, 3D printed tray materials can provide clinically adequate bond strength with the elastomeric impression/adhesive systems. PLA is recommended for bonding with VPS when severe impression removal resistance is detected.