Overlay measurement and analysis of x-ray/optical lithography for mix-and-match device applications

A joint Motorola/IBM experiment was performed in mix-and-match lithography across widely separated locations. A simple pattern placement metrology data set was created, and x-ray masks were manufactured according to this data. The same data was converted into a 5x reticle and optically stepped on wafers. The x-ray mask was designed to print upon two optical fields with one x-ray exposure. The x-ray mask was aligned to the wafers to produce box-in- box images for overlay metrology. The main overlay problems encountered were systematic offsets between x-ray and optical images, and average magnification error of approximately 8 ppm. The magnification error is substantial because of the 3 degree(s)C temperature difference between the optical stepper stage and the x-ray mask-writer. In an actual device run, the magnification differences will be removed by compensation in the e-beam writing of the x-ray mask. Offsets will be removed by use of a send-ahead wafer to determine the correct offset alignment in the x-ray stepper.