Analysis of Resistance According to Metal Ribbon Connection for Application to Interconnection of Shingled Photovoltaic Strings.

The Shingle Photovoltaic (PV) module is a new high power PV module technology manufactured by 'Dividing and ECA (Electrical Conductivity Adhesive) bonding' method for solar cell. In the case of a general PV module, a metal ribbon is soldered on the bus bar of the solar cell and connected to others. The dividing/ECA bonding technology connects the divided cells through bonding to manufacture a string. In order to make a module, the fabricated strings must be connected with Bus ribbon. The Shingled strings produced by the dividing and bonding method are not limited to the interconnection method by the metal ribbon. Also, it is not standardized for interconnections between strings. Therefore, we analyzed the characteristics of the shingled strings according to the soldering method. The characteristics of the string vary depending on the number of metal ribbons that contact the solar cell electrodes. Experimental results show that the series resistance increases significantly with fewer contacts. As a result, the efficiency of two-point contact decreased by 0.458%, four-point contact decreased by 0.048%, and eight-point contact decreased by 0.034%. This is because as the number of contacts increases, the resistance of the busbars becomes smaller and the contact resistance becomes smaller.