Salmonella Inactivation During Extrusion of an Oat Flour Model Food

Little research exists on Salmonellainactivation during extrusion processing, yet many outbreaks associated with low water activity foods since 2006 were linked to extruded foods. The aim of this research was to study Salmonellainactivation during extrusion of a model cereal product. Oat flour was inoculated with Salmonellaenterica serovar Agona, an outbreak strain isolated from puffed cereals, and processed using a single‐screw extruder at a feed rate of 75 kg/h and a screw speed of 500 rpm. Extrudate samples were collected from the barrel outlet in sterile bags and immediately cooled in an ice–water bath. Populations were determined using standard plate count methods or a modified most probable number when populations were low. Reductions in population were determined and analyzed using a general linear model. The regression model obtained for the response surface tested was Log (NR/NO) = 20.50 + 0.82T− 141.16aw– 0.0039T2+ 87.91aw2(R2= 0.69). The model showed significant (p< 0.05) linear and quadratic effects of awand temperature and enabled an assessment of critical control parameters. Reductions of 0.67 ± 0.14 to 7.34 ± 0.02 log CFU/g were observed over ranges of aw(0.72 to 0.96) and temperature (65 to 100 °C) tested. Processing conditions above 82 °C and 0.89 awachieved on average greater than a 5‐log reduction of Salmonella. Results indicate that extrusion is an effective means for reducing Salmonellaas most processes commonly employed to produce cereals and other low water activity foods exceed these parameters. Thus, contamination of an extruded food product would most likely occur postprocessing as a result of environmental contamination or through the addition of coatings and flavorings. This study investigated inactivation of Salmonellaenterica serovar Agona during extrusion processing of an oat flour model food over a wide range of water activity (0.72 to 0.96) and temperature (65 to 100 °C). Results of this study indicate that extrusion is an effective means for reducing bacterial pathogens and may be used by industry when establishing critical limits for extrusion processes.