The aim of the present study was to explore the capabilities of the combination of 1H NMR (proton nuclear magnetic resonance) mixture analysis and HPLC-SPE-NMR/TOF-MS (high-performance liquid chromatography coupled to solid-phase extraction and nuclear magnetic resonance and time-of-flight mass spectrometry) for the characterization of xenobiotic contaminants in groundwater samples. As an example, solid-phase extracts of two groundwater samples taken from a former ammunition destruction site in Switzerland were investigated. 1H NMR spectra of postcolumn SPE enriched compounds, together with accurate mass measurements, allowed the structural elucidation of unknowns. This untargeted approach allowed us to identify expected residues of explosives such as 2,4,6-trinitrotoluene (2,4,6-TNT), Hexogen (RDX) and Octogen (HMX), degradation products of TNT (1,3,5-trinitrobenzene (1,3,5-TNB), 2-amino-4,6-dinitrotoluene (2-A-4,6-DNT), 3,5-dinitrophenol (3,5-DNP), 3,5-dinitroaniline (3,5-DNA), 2,6-dinitroanthranite, and 2-Hydroxy-4,6-dinitrobenzonitrile), benzoic acid, Bisphenol A (a known endocrine disruptor compound), and some toxicologically relevant additives for propelling charges: Centralite I (1,3-diethyl-1,3-diphenylurea), DPU (N,N-diphenylurethane), N,N-diphenylcarbamate (Acardite II), and N-methyl-N-phenylurethane. To our knowledge, this is the first report of the presence of these additives in environmental samples. Extraction recoveries for Centralite I and DPU have been determined. Contaminants identified by our techniques were quantified based on HPLC-UV (HPLC-ultraviolet detection) and 1H NMR mixture analysis. The concentrations of the contaminants ranged between 0.1 and 48 microg/L assuming 100% recovery for the SPE step.
The X-ray induced photoemission from clean pure plutonium metal is described and the results for both core and valence levels are compared with previous measurements on light actinides. It is found that, as in thorium and uranium, the configuration interaction plays an important role for core levels, in particular for those of the n=5 shell. The experimental valence-band spectrum confirms the existence of 5f states at the Fermi level and is compared with a density of states of FCC Pu derived from a recent relativistic band structure calculation.
Sulfidopeptide leukotrienes, which are important biomarkers for several diseases, are commonly measured by microtiter plate immunoassays. These immunoassays, however, cannot distinguish between several structurally similar leukotrienes and their cross-reactive metabolites and, therefore, need extensive sample handling and fractionation by means of liquid chromatography (LC). This paper describes the development and automation of a continuous-flow immunochemical detection (ICD) system and its subsequent on-line coupling to LC. The on-line LC-ICD system based on fluorescence-labeled leukotriene E4 (LTE4) was used to determine sulfidopeptide leukotrienes and their cross-reactive metabolites in a single run. Furthermore, biological matrices, e.g., urine and human cell extracts, were analyzed, the only sample pretreatment being on-line solid-phase extraction (SPE) on a novel RP-C4 restricted-access support. The determination limit of LTE4 in urine was 0.2 ng/mL (800 fmol; injection volume, 2000 microL; signal-to-noise ratio, 10). The system was linear from 0.2 to 1.0 ng/mL LTE4. Using nonlinear curve-fitting, the range could be expanded to 2.5 ng/mL. It is shown that, besides quantitation of known analytes, on-line LC-ICD is useful in the discovery of cross-reactive LTE4 metabolites.
'/%3e%3cuse xlink:href='%23a' transform='translate(288.889 -214.211)'/%3e%3cuse xlink:href='%23a' transform='translate(108 342.749)'/%3e%3cuse xlink:href='%23a' transform='translate(469.189 342.749)'/%3e%3c/svg%3e)