Polyphenols are known for their antimicrobial activity, whilst both polyphenols and the globular protein β-lactoglobulin (bLG) are suggested to have antioxidant properties and promote cell proliferation. These are potentially useful properties for a tissue-engineered construct, though it is unknown if they are retained when both compounds are used in combination. In this study, a range of different microbes and an osteoblast-like cell line (human fetal osteoblast, hFOB) were used to assess the combined effect of: (1) green tea extract (GTE), rich in the polyphenol epigallocatechin gallate (EGCG), and (2) whey protein isolate (WPI), rich in bLG. It was shown that approximately 20–48% of the EGCG in GTE reacted with WPI. GTE inhibited the growth of Gram-positive bacteria, an effect which was potentiated by the addition of WPI. GTE alone also significantly inhibited the growth of hFOB cells after 1, 4, and 7 days of culture. Alternatively, WPI significantly promoted hFOB cell growth in the absence of GTE and attenuated the effect of GTE at low concentrations (64 µg/mL) after 4 and 7 days. Low concentrations of WPI (50 µg/mL) also promoted the expression of the early osteogenic marker alkaline phosphatase (ALP) by hFOB cells, whereas GTE inhibited ALP activity. Therefore, the antioxidant effects of GTE can be boosted by WPI, but GTE is not suitable to be used as part of a tissue-engineered construct due to its cytotoxic effects which negate any positive effect WPI has on cell proliferation.
Mineralization of hydrogel biomaterials is desirable to improve their suitability as materials for bone regeneration. In this study, gellan gum (GG) hydrogels were formed by simple mixing of GG solution with bioactive glass microparticles of 45S5 composition, leading to hydrogel formation by ion release from the amorphous bioactive glass microparticles. This resulted in novel injectable, self-gelling composites of GG hydrogels containing 20% bioactive glass. Gelation occurred within 20 min. Composites containing the standard 45S5 bioactive glass preparation were markedly less stiff. X-ray microcomputed tomography proved to be a highly sensitive technique capable of detecting microparticles of diameter approximately 8 μm, that is, individual microparticles, and accurately visualizing the size distribution of bioactive glass microparticles and their aggregates, and their distribution in GG hydrogels. The widely used melt-derived 45S5 preparation served as a standard and was compared with a calcium-rich, sol–gel derived preparation (A2), as well as A2 enriched with zinc (A2Zn5) and strontium (A2Sr5). A2, A2Zn, and A2Sr bioactive glass particles were more homogeneously dispersed in GG hydrogels than 45S5. Composites containing all four bioactive glass preparations exhibited antibacterial activity against methicillin-resistant Staphylococcus aureus. Composites containing A2Zn5 and A2Sr5 bioactive glasses supported the adhesion and growth of osteoblast-like cells and were considerably more cytocompatible than 45S5. All composites underwent mineralization with calcium-deficient hydroxyapatite upon incubation in simulated body fluid. The extent of mineralization appeared to be greatest for composites containing A2Zn5 and 45S5. The results underline the importance of the choice of bioactive glass when preparing injectable, self-gelling composites.
Hydrogels that possess the ability of gelling in response to changes in the local environment, such as pH or temperature, have been examined extensively recently. In this paper the properties of thermosensitive chitosan hydrogels prepared with the use of chitosan glutaminate and β-glycerophosphate are presented. The sol/gel transition point was determined based on the rheological properties. The structure of gels was observed under the Scanning Electron Microscopy (SEM) and was investigated by thermogravimetric (TG) and differential themogravimetric (DTG) analy sis and infrared (IR) spectroscopy. The crystallinity of gel structure was determined by X-ray Diffraction analysis (XRD).
This study involves the synthesis of hydroxyapatite and describes the preparation and characterization of polymer coatings based on poly(ethylene glycol) diacrylate and poly(ethylene glycol) and modified with bovine serum albumin and hydroxyapatite. Hydroxyapatite was obtained by wet chemical synthesis and characterized by X-ray diffraction and FTIR spectroscopy, and its Ca/P molar ratio was determined (1.69 ± 0.08). The ceramic and bovine serum albumin were used in the preparation of composite materials with the polymeric matrix. The chemical composition of coatings was characterized with FTIR spectroscopy, and their morphology was recorded with SEM imaging. Moreover, the measurements of surface roughness parameters and stereometric research were performed. The prepared coatings were subjected to in vitro studies in simulated body fluid and artificial saliva. Changes in chemical composition and morphology after immersion were examined with FTIR spectroscopy and SEM imaging. Based on the conducted research, it can be stated that applied modifiers promote the biomineralization process. The roughness analysis confirmed prepared materials were characterized by the micrometer-scale topography. The materials morphology and roughness, and the morphology of the newly formed apatite deposit, were dependent on the type of the used modifier, and the artificial fluid used in in vitro studies.
Biomaterials to support bone regeneration in maxillofacial and orthopedic surgery is gaining in importance due to the aging population. The most commonly used biomaterials are ceramics consisting of calcium phosphate (CaP) due to their bioactivity, or ability to form a direct bone with surrounding bone. However these have drawbacks, including lack of ease of incorporation of antimicrobial agents. Antibacterial properties are highly desirable, as >2% of implants are contaminated. The use of hydrogels mineralized with CaP allows for bioactivity, while antibacterial agents can easily be incorporated in the hydrogel phase. Polyphenols are known to possess antibacterial activity, but their incorporation into biomaterials to combat bacterial colonoization remains unexplored. In our studies, hydrogels consisting of gellan gum (GG) were enzymatically mineralized with calcium phosphate (CaP) using alkaline phosphatase (ALP) as in previous work (1). We incorporated a polyphenol-rich plant extract into GG hydrogels and discovered that growth of the antibiotic-resistant bacteria Methicillin-resistant Staphylococcus aureus (MRSA) on hydrogels was inhibited, both before and after mineralization with CaP. Furthermore, hydrogel mineralization was enhanced. These results prove the principle of exploiting the polyphenols to endow antibacterial activity to biomaterials for bone regeneration.
Membranes of the autologous blood-derived biomaterial platelet-rich fibrin (PRF) were functionalized by incorporation of alkaline phosphatase (ALP), an enzyme involved in mineralization of bone, and subsequently incubated in calcium glycerophosphate (CaGP) solution to induce PRFs mineralization with calcium phosphate (CaP) to improve PRFs suitability as a material for bone replacement. Incorporated ALP retained its bioactivity and induced formation of CaP material within PRF membranes, as confirmed by SEM, EDS, FTIR, and von Kossa staining. The mass percentage attributable to CaP was quantified by lyophilization and measurement of the remaining mass fraction as well as by TGA. Cytocompatibility tests (LDH, MTT, and WST) with SAOS-2 cells showed that mineralized PRF did not release substances detrimental to cell vitality. Live/dead staining and SEM showed that mineralized PRF was colonized by cells. The results show that hydrogel biomaterials such as PRF can be mineralized through functionalization with ALP.
Injectable composites for tissue regeneration can be developed by dispersion of inorganic microparticles and cells in a hydrogel phase. In this study, multifunctional carbonate microparticles containing different amounts of calcium, magnesium and zinc were mixed with solutions of gellan gum (GG), an anionic polysaccharide, to form injectable hydrogel-microparticle composites, containing Zn, Ca and Mg. Zn and Ca were incorporated into microparticle preparations to a greater extent than Mg. Microparticle groups were heterogeneous and contained microparticles of differing shape and elemental composition. Zn-rich microparticles were 'star shaped' and appeared to consist of small crystallites, while Zn-poor, Ca- and Mg-rich microparticles were irregular in shape and appeared to contain lager crystallites. Zn-free microparticle groups exhibited the best cytocompatibility and, unexpectedly, Zn-free composites showed the highest antibacterial activity towards methicilin-resistant Staphylococcus aureus. Composites containing Zn-free microparticles were cytocompatible and therefore appear most suitable for applications as an injectable biomaterial. This study proves the principle of creating bi- and tri-elemental microparticles to induce the gelation of GG to create injectable hydrogel-microparticle composites.
'%3e%3cpath fill='%23012169' d='M0 0v30h60V0z'/%3e%3cpath stroke='%23fff' stroke-width='6' d='m0 0 60 30m0-30L0 30'/%3e%3cpath stroke='%23C8102E' stroke-width='4' d='m0 0 60 30m0-30L0 30' clip-path='url(%23b)'/%3e%3cpath stroke='%23fff' stroke-width='10' d='M30 0v30M0 15h60'/%3e%3cpath stroke='%23C8102E' stroke-width='6' d='M30 0v30M0 15h60'/%3e%3c/g%3e%3c/svg%3e)
