Gadolinium-doped injectable magnesium-calcium phosphate bone cements for noninvasive visualization
П. А. КрохичеваM. A. GoldbergА. С. ФоминDinara R. KhayrutdinovaО. С. АнтоноваMargarita A. SadovnikovaIvan V. MikheevAleksander V. LeonovEkaterina M. MerzlyakDaria A. KovalishinaС. А. АхмедоваН. С. СергееваMarat GafurovС. М. БариновВ. С. Комлев
0
Citation
88
Reference
10
Related Paper
Keywords:
Magnesium phosphate
Magnesium phosphate
Cite
Citations (2)
Magnesium phosphate
Potassium phosphate
Cite
Citations (30)
Objective:To observe the corrosion behavior of pure magnesium in different corrosive media,and explore the possible degradation mechanism.Methods:According to ASTM-G31-72 standard used simulated body fluid(SBF) and Dulbecco's modify Eagle medium(DMEM)for immersion media to immerse pure magnesium.Measured calcium,magnesium ion concentration and system pH changes in the different time point.The changes of material surface morphology were investigated by scanning electron microscopy,EDS and XRD.Results: After immersing 8 days,the samples in SBF could not observe the complete shape,while the samples' shape were completed in DMEM.The magnesium ion release quantity and calcium consumption in SBF solution are obviously higher than that of the DMEM solution.The changes of pH in two kinds of corrosion medium did not present too big difference,and the pH was maintained at about 10.0 finally.The product of pure magnesium which soaked in the two kinds of corrosion medium presented big difference.Samples' surface in the SBF system generated magnesium hydroxide,and emerged a small amount of magnesium phosphate precipitation.While in DMEM,there has been a lot of magnesium monohydrogen phosphate,magnesium phosphate,and a small amount of magnesium hydroxide crystals.Conclusion:The SBF system of the corrosion rate was significantly higher than DMEM.Pure magnesium corrosion products generated differently at different time points in the SBF system and DMEM.
Simulated body fluid
Magnesium phosphate
Immersion
Cite
Citations (0)
Determination of magnesium oxide from food grade magnesium phosphate was studied by dissolution of samples with dilute hydrochloric acid,coordination with EDTA standard solution and back titration with magnesium sulfate standard solution.The recovery and relative standard deviation were 97～103% and less than 0.21% respectively.
Hydrochloric acid
Magnesium phosphate
Complexometric titration
Standard solution
Cite
Citations (0)
SUMMARY Growing wether sheep in metabolism cages were fed a low phosphorus diet (0·75g P/day) supplemented with 1·75 g P/day as either a magnesium phosphate (20·0% Mg, 18·5% P) or a calcium magnesium phosphate (16·1% Ca, 6·0% Mg, 18·5% P). In addition, the magnesium phosphate provided 1·87 g Mg/day and the calcium magnesium phosphate 0·57 g Mg/day. In each case comparisons were made with equivalent amounts of phosphorus and magnesium supplied as dicalcium phosphate (26·5% Ca, 16·0% P) and magnesium oxide (60·0% Mg). All the supplements resulted in similar positive phosphorus retentions of between 0·77and 0·92 g P/day compared with a daily loss of 0·17 g P/day for the low phosphorus diet. Calcium retentions were higher (1·40 and 1·70 g Ca/day) whendicalcium phosphate rather than the magnesium phosphates (1·16 g Ca/day) were given. Magnesium retentions were increased from 0·1 g Mg/day (unsupplemented) to 0·3–0·4 gMg/day and were similar for both magnesium oxide and the magnesium phosphates. Blood phosphorus and magnesium concentrations were increased to a similar degree by all forms of supplementation.
Magnesium phosphate
Magnesium deficiency (plants)
Cite
Citations (11)
Cite
Citations (10)
The capacity of 10%, 30%, and 50% ammonium dihydrogen phosphate were replaced with an equal amount of three phosphate (potassium dihydrogen phosphate, sodium dihydrogen phosphate, disodium hydrogen phosphate) respectively. Magnesium phosphate cement was made by phosphate of replaced, which strength, setting time, fluidity, hydration temperature, and the hydration products was researched. The results show that: MPC was made that replaced with the equal amount of three kind of phosphate, which has good mechanical properties. Setting time and fluidity change along with the replacment. Three kind of phosphate replace ammonium dihydrogen phosphate, which change the hydration process of MPC. When ammonium dihydrogen phosphate was replaced by an equal amount of disodium hydrogen phosphate, the temperature of hydration is only 69.4 °C. XRD showed that the diffraction peaks of composite’s magnesium phosphate cement increases.
Ammonium dihydrogen phosphate
Magnesium phosphate
Potassium phosphate
Hydrogen phosphate
Cite
Citations (0)
Magnesium phosphate
Cite
Citations (63)
MgO was prepared via washing to reduce the impurity of the ion content of the lithium-extracting magnesium slag, a by-product of the Salt Lake and obtained via the membrane separation method, followed by calcination.The MgO was used as a raw material to prepare magnesium potassium phosphate cement (MKPC).Through analyses including X-ray diffraction, scanning electron microscopy, hydration heat release rate, hydration products and porosity, the effects of the impurity of the ion content, and calcination temperature on the physicochemical and MKPC properties of MgO in the lithium-extracting magnesium slag were explored.The results show that the impurity of the ion content and calcination temperature only change the specific surface and crystal morphology of MgO, but not the basic phase composition.The optimal process for the preparation of MKPC from the lithium-extracting magnesium slag included washing to a filtrate the conductivity of 5000 μS•cm -1 and calcination at 1200 ℃.The MKPC prepared by this combination exhibited the longest setting time, the highest strength in the later stage, and no shrinkage.Regarding its microscopic morphology, the K-struvite structure had the largest size, most regular arrangement, and lowest porosity.This combination was also the most economical and met the requirement of low energy consumption.
Magnesium phosphate
Slag (welding)
Cite
Citations (2)
This study investigated the biocompatibility of strontium-doped calcium phosphate (Sr-CaP) coatings on pure magnesium (Mg) surfaces for bone applications. Sr-CaP coated specimens were obtained by chemical immersion method on biodegradable magnesium. In this study, Sr-CaP coated magnesium was obtained by immersing pure magnesium in a solution containing Sr-CaP at 80 °C for 3 h. The corrosion resistance and biocompatibility of magnesium according to the content of Sr-CaP coated on the magnesium surface were evaluated. As a result, the corrosion resistance of Sr-CaP coated magnesium was improved compared to pure magnesium. In addition, it was confirmed that the biocompatibility of the group containing Sr was increased. Thus, the Ca-SrP coating with a reduced degradation and improved biocompatibility could be used in Mg-based orthopedic implant applications.
Biocompatibility
Magnesium phosphate
Simulated body fluid
Cite
Citations (5)