logo
    Effect of anions on the anodic dissolution behavior of iron: An electrochemical and density functional theory study
    4
    Citation
    71
    Reference
    10
    Related Paper
    Citation Trend
    'Disintegration' and 'dissolution' of solid drug dosage forms are considered as partial processes of drug liberation. Besides the (apparent) disintegration time that is determined in the official disintegration tester, there is a second (intrinsic) disintegration time which can be deduced from the experimental dissolution data, but shows only limited correlation with the former. Various methods for the graphical resolution of dissolution data and the calculation of the intrinsic disintegration time therefrom are discussed. For the simultaneous determination of disintegration and dissolution, the approved rotating flask method is recommended.
    Liberation
    Citations (0)
    The dissolution of minerals in water is typically studied on macroscopic length- and time-scales, by detecting dissolution products in bulk solution and deducing reaction rates from model assumptions. Here, we report a direct, real-time measurement of silica dissolution, by monitoring how dissolution changes the first few interfacial layers of water in contact with silica, using surface-specific spectroscopy. We obtain direct information on the dissolution kinetics of this geochemically relevant mineral. The interfacial concentration of dissolution products saturates at the level of the solubility limit of silica (~millimolar) on the surprisingly short timescale of tens of hours. The observed kinetics reveal that the dissolution rate increases substantially with progressing dissolution, suggesting that dissolution is an auto-catalytic process.
    Citations (41)
    Abstract Thorium oxide is poorly soluble: unlike uranium oxide, concentrated nitric acid medium is not sufficient to get quantitative dissolution. Addition of small amounts of fluoride is required to achieve thorium oxide total dissolution. The effect of several parameters on thorium oxide dissolution in order to optimize the dissolution conditions is reported in this paper. Thus the influence of solid characteristics, dissolution method, temperature and composition of dissolution medium on ThO 2 dissolution rate has been studied. No complexing agents tested other than fluoride allows total dissolution. Beyond a given HF concentration a decrease of the dissolution rate is observed due to the formation of a precipitate at the solid/solution interface. It was demonstrated by XPS measurements that this precipitate is constituted of thorium fluoride (ThF 4 ) formed during the ThO 2 dissolution. The low concentration of HF required to achieve a total dissolution and the activation energy value measured tends to show a catalytic effect of HF on the dissolution process.
    Citations (6)
    To understand salt spray corrosion behavior and corrosion mechanism,the resistance of salt sprays corrosion for a Fe-based alloy 30Cr2Ni4MoV used in ship had been studied in the paper.The surface and section of samples corroded for different times,the corrosion products,the corrosion weight loss and corrosion ratio had been analyzed.The result showed that after corrosion 400 h,the surface of samples had been covered with corrosion products,and some corrosion products had separated from the substrate.The main component of corrosion product was FeO(OH).The corrosion of 30Cr2Ni4MoV started form the corrosion pits,and then extended.While the corrosion extent of samples tended to be same,new corrosion pits appeared,and corrosion continued.In the first 100 h,the corrosion rate changed greatly.
    Citations (0)
    In this paper the theoretical background of dissolution determining the oral administration, the physicochemical and physiological factors influencing the rate of dissolution, the relation between solubility and dissolution, the most important pharmacopoeial and miniaturized dissolution measurements and finally the dissolution in biorelevant media are reviewed.
    Citations (0)