Corrosion behaviour improvement from the ultrafine-grained Al–Zn–In alloys in Al–air battery
Siwat LinjeeSuphitcha MoonngamPitichon KlomjitNamurata Sathirachinda PålssonChaiyasit Banjongprasert
28
Citation
46
Reference
10
Related Paper
Citation Trend
Abstract:
Corrosion of aluminium anode in alkaline solution is a challenging matter for the development of a long-life aluminium anode in Al–air battery. This research focuses on grain size reduction by equal channel angular pressing (ECAP) of Al, Al–Zn, and Al–Zn–In samples. The average grain size of all samples after ECAP is lower than 1μm. Open circuit potential, potentiodynamic polarisation, electrochemical impedance spectroscopy, and self-corrosion test were carried out to study the effects of alloying elements (Zn, In) and grain size reduction by ECAP on the electrochemical behaviours of aluminium alloy anodes. The results show that alloying element, zinc, can improve the stability of ion dissolution by porous Al2ZnO4 film formation. Indium can activate ion dissolution that causes enhanced electrochemical activities for Al–Zn–In sample. Moreover, increasing grain boundaries through grain size reduction can enhance more negative potential and cause a uniformly corroded surface of Al–Zn–In sample, leading to a longer anode life in alkaline solution.Keywords:
Galvanic anode
Suspension
Cite
Citations (64)
Cite
Citations (10)
Galvanic cell
Galvanic anode
Salt spray test
Cite
Citations (207)
'Disintegration' and 'dissolution' of solid drug dosage forms are considered as partial processes of drug liberation. Besides the (apparent) disintegration time that is determined in the official disintegration tester, there is a second (intrinsic) disintegration time which can be deduced from the experimental dissolution data, but shows only limited correlation with the former. Various methods for the graphical resolution of dissolution data and the calculation of the intrinsic disintegration time therefrom are discussed. For the simultaneous determination of disintegration and dissolution, the approved rotating flask method is recommended.
Liberation
Cite
Citations (0)
The dissolution of minerals in water is typically studied on macroscopic length- and time-scales, by detecting dissolution products in bulk solution and deducing reaction rates from model assumptions. Here, we report a direct, real-time measurement of silica dissolution, by monitoring how dissolution changes the first few interfacial layers of water in contact with silica, using surface-specific spectroscopy. We obtain direct information on the dissolution kinetics of this geochemically relevant mineral. The interfacial concentration of dissolution products saturates at the level of the solubility limit of silica (~millimolar) on the surprisingly short timescale of tens of hours. The observed kinetics reveal that the dissolution rate increases substantially with progressing dissolution, suggesting that dissolution is an auto-catalytic process.
Cite
Citations (41)
Abstract Thorium oxide is poorly soluble: unlike uranium oxide, concentrated nitric acid medium is not sufficient to get quantitative dissolution. Addition of small amounts of fluoride is required to achieve thorium oxide total dissolution. The effect of several parameters on thorium oxide dissolution in order to optimize the dissolution conditions is reported in this paper. Thus the influence of solid characteristics, dissolution method, temperature and composition of dissolution medium on ThO 2 dissolution rate has been studied. No complexing agents tested other than fluoride allows total dissolution. Beyond a given HF concentration a decrease of the dissolution rate is observed due to the formation of a precipitate at the solid/solution interface. It was demonstrated by XPS measurements that this precipitate is constituted of thorium fluoride (ThF 4 ) formed during the ThO 2 dissolution. The low concentration of HF required to achieve a total dissolution and the activation energy value measured tends to show a catalytic effect of HF on the dissolution process.
Cite
Citations (6)
Cite
Citations (8)
Cite
Citations (0)
Gastric fluid
Cite
Citations (21)
In this paper the theoretical background of dissolution determining the oral administration, the physicochemical and physiological factors influencing the rate of dissolution, the relation between solubility and dissolution, the most important pharmacopoeial and miniaturized dissolution measurements and finally the dissolution in biorelevant media are reviewed.
Cite
Citations (0)