Effect of heat treatment in vacuum on photoluminescence of anodic alumina

: The results are presented of a study of the photoluminescent (PL) properties of an undoped porous anodic alumina (PAA) and PAA doped with manganese ions. The PAA samples were prepared by anodization of aluminum. The effect of annealing conditions in vacuum on the PL spectra was studied for the first time and a comparative analysis was made with the spectra of the PAA annealed in air. Vacuum annealing was used to obtain oxygen-deficient alumina. A strong dependence of the PAA PL intensity on the annealing temperature in vacuum has been found: for the samples annealed at 600°С, the PL intensity is 15 times higher than that measured on the initial samples, whereas for the samples annealed in air it increases only 4.5-fold with excitation at the wavelengths of 275 nm. This is the result of the formation of a high concentration of oxygen vacancies during annealing in vacuum under conditions of oxygen deficiency as compared with the samples annealed in air, where diffusion of oxygen from air leads to a decrease in vacancies. A significant increase in the PL intensity permits consideration of the vacuum-annealed PAA as a promising material for dosimetry.