Effect of Different Pressures on Microstructure and Mechanical Performance of F-III Fibers in Supercritical Carbon Dioxide Fluid

F-III fibers were treated at different pressures in supercritical carbon dioxide fluid and all samples including untreated and treated F-III fibers were characterized by a mechanical performance tester, wide-angle X-ray scattering and small-angle X-ray scattering. By studying the relationship between mechanical performance and microstructural changes of the samples, it was found that microstructural change was the main cause of variation in mechanical performance. Results revealed that the maximum tensile strength and modulus of F-III fibers were acquired at 14 MPa within the pressure range of 8 MPa to 16 MPa when the temperature, tension and time were 250 °C, 6 g·d−1 and 40 min, respectively. Correspondingly, the microstructures of the samples, including the phase fraction, crystal size, orientation factor, fibril radius, fibril length and misorientation angle, have been investigated. It was fortunate that the supercritical carbon dioxide fluid could be used as a medium during the hot-stretch process to improve the mechanical performance of F-III fibers, although the treatment temperature was lower than the glass transition temperature of the F-III fibers.