Particle size, morphology and phase transitions in hydrothermally produced VO2(D)

Different morphologies and sizes of VO2(D) particles were synthesised via hydrothermal synthesis using ammonium metavanadate (NH4VO3) or vanadium pentoxide (V2O5) as a vanadium precursor. By adjusting the concentration of vanadium precursors and the pH of the starting solution, a variety of morphologies and sizes of VO2(D) particles from 20 nm to 3 μm could be produced. A flower-shape morphology was obtained under strongly acidic conditions, passing through star-shape particles of 1 μm at pH 2.5 and finally obtaining homogeneous round balls of around 3 μm at pH 6.9. Nanoparticles were produced hydrothermally using V2O5 as a precursor and hydrazine as a reducing agent. The transition from VO2(D) to thermochromic VO2(R) in micron scale particles occurred at 350 °C under vacuum. However, the nanoparticles of VO2(D) had a significantly lower VO2(D) to thermochromic VO2(R) transition temperature of 165 °C after annealing for only a few minutes. This is, to our knowledge, the lowest annealing temperature and time reported in the literature in order to obtain a thermochromic VO2 material via another VO2 phase. After the conversion of VO2(D) microparticles to thermochromic VO2(R), the metal to insulator transition temperature is 61 ± 1 °C for the heating cycle and 53 ± 1 °C for the cooling cycle. However, VO2(R) nanoparticles showed a significantly reduced metal insulator transition temperature of 59 ± 1 °C and 42 ± 1 °C for the cooling cycle lower than that reported in the literature for bulk VO2. This is important due to the need for having a compound with a switching temperature closer to room temperature to be used in smart window devices for energy consumption. W-VO2(D) star shape microparticle samples were prepared using 2–7 at% of the dopant (using ammonium metavanadate as a precursor), although unexpectedly this does not seem to be a viable route to a reduced metal to insulator transition in this system.