Тестирование быстроты и точности движений

Testing the speed and accuracy of movement. Polevschikov M.M., Rozhentsov V.V. Surveyed offer to perform in a given time at a maximum rate of movement of the probe sequentially pads located at the corners of a flat triangular or polygonal shapes, touching the contact points located in the center of the contact pads. The contact points are surrounded by N concentric zones, isolated from each other and from the contact point. Contact points and concentric zones of contact pads are connected to the inputs of the computer. The distance between adjacent concentric zones and between the inner concentric area and contact point corresponds to the diameter of the probe. The subject makes a motion to probe pads, trying to touch the contact points. Contact probe in concentric outer zone corresponds to 1 point, each subsequent penetration into the inner area – more than 1 point to the contact point – (N + 1) -th point each. In case of contact between the probe concentric zones or between the inner concentric area and contact point when the probe touches them at the same time, estimated the number of points corresponding to the inner concentric zone or contact point, respectively. The computer calculated the total number of movements, equal to the number of touches probe pads, and the number dialed as a result of touch points. Speed of movement measured by the total number of movements, precise movements – the number of points.