In situ seismic measurements in claystone at Tournemire (France)

Compressional and shear wave seismic measurements were performed in an old railway tunnel and in galleries excavated in a 250-m-thick Toarcian claystone formation in the Tournemire experimental station (France). Three component (3C) geophones and three orthogonal orientations of the vibroseismic force source were used. Additionally, vertical seismic profiling (VSP) measurements were recorded with a 3C borehole geophone, a hydrophone and a microphone in a 159 m deep borehole (ID180) in the tunnel. The seismic data show that Toarcian claystone has strong transverse isotropy (TI) with a vertical symmetry axis. The qP, SH and qSV wave propagation velocities in horizontal directions-the plane of isotropy of the TI medium-are measured as 3550, 1850 and 1290 m s-1, respectively. The zero-offset VSP reveals that only one shear wave propagates in the vertical (depth) direction and the P- and S-wave velocities are 3100 and 1375 m s-1, respectively. Four elastic moduli of the TI medium are determined from the seismic velocities and from the bulk density of 2.53 g cm-3 c11 = 31.9 GPa, c33 = 24.3 GPa, c44 = 4.5 GPa and c66 = 8.7 GPa. A walkaway VSP with the borehole geophone at 50 m depth in borehole ID180 and shot points in the galleries leads to oblique seismic ray paths which allow us to determine the fifth elastic modulus of the TI medium to c13 = 16 GPa. The tube wave recorded by a hydrophone in the water filled lower part of the borehole propagates with 1350 m s-1, which confirms the estimate of the elastic constant c66. The analysis of body wave and surface wave data from a seismic experiment in Galerie Est shows reflections from several fracture zones in the gallery floor. The thickness of the excavation damaged zone (EDZ) in the floor of Galerie Est is estimated to 0.7 m. © The Authors 2014. Published by Oxford University Press on behalf of The Royal Astronomical Society.