Improvements to the methods used to measure bubble attenuation using an underwater acoustical resonator

Active acoustic techniques are commonly used to measure oceanic bubble size distributions, by inverting the bulk acoustical properties of the water (usually the attenuation) to infer the bubble population. Acoustical resonators have previously been used to determine attenuation over a wide range of frequencies (10–200 kHz) in a single measurement, corresponding to the simultaneous measurement of a wide range of bubble sizes (20–300 μm radii). However, there is now also considerable interest in acquiring measurements of bubbles with radii smaller than 16 μm, since these are thought to be important for ocean optics and as tracers for near-surface flow. To extend the bubble population measurement to smaller radii, it is necessary to extend the attenuation measurements to higher frequencies. Although the principles of resonator operation do not change as the frequency increases, the assumptions previously made during the spectral analysis may no longer be valid. In order to improve the methods used to calcula...