Coarsening- and Creep Resistance of Precipitation-Strengthened Al-Mg-Zr Alloys Processed by Selective Laser Melting

Abstract The coarsening behavior of Al3Zr precipitates during aging was investigated for two Al-Mg-Zr alloys (Al-3.6Mg-1.2Zr and Al-2.9Mg-2.1Zr, wt.%) processed by selective laser melting (SLM). Scanning transmission electron microscopy (STEM) investigations of peak-aged (400˚C, 8 h) samples reveal both continuous (∼2 nm in diameter) and discontinuous (∼5 nm wide and hundreds of nanometers in length) coherent, secondary L12-Al3Zr precipitates. In-situ STEM experiments showed that aging at 400˚C results in the appearance and growth of both grain-boundary Al3Zr precipitates, and intragranular nanometer-sized spherical Al3Zr precipitates in Zr-rich dendritic arms. Heating to 500˚C resulted in the disappearance of most Al3Zr precipitates and oxide particles. This microstructural evolution sheds light on the evolution of the alloy strength at elevated temperature. For short-term yield tests, as-fabricated samples displayed higher yield strengths than peak-aged samples at temperatures above 150˚C (e.g., 87 vs 24 MPa at 260˚C). This is attributed to coarsening of grain-boundary precipitates during aging, decreasing their ability to inhibit grain-boundary sliding (GBS) of the fine equiaxed grains (∼1 µm). For longer term creep tests at 260 ˚C, both as-fabricated and peak-aged samples displayed near-identical creep behavior during a long-duration (168 h) creep test; by contrast, during a shorter duration creep test (8 h), as-fabricated samples are more creep-resistant than samples previously aged at 260 ˚C (threshold stresses of ∼40 vs. ∼14 MPa, respectively). Again, the creep behavior is consistent with coarsening of grain-boundary precipitates, occurring now during long-duration creep tests at 260 ˚C. An exact creep mechanism could not be isolated due to microstructural changes during testing but is believed to be a combination of GBS and dislocation motion.