Mechanical Performance of Auxetic Polyurethane Foam for Antivibration Glove Applications

In this study the static and dynamic characteristics of conventional open cell polyurethane (PU), of auxetic (negative Poisson’s ratio) and of iso-density foams were analysed. The specimens were produced from conventional gray open-cells polyurethane foam with 30-35 pores/inch and 0.0027 g/cm 3 density, by means of process which has been previously defi ned by the authors. Poisson’s ratio measurements were performed under quasi-static conditions using an MTS 858 servo-hydraulic test machine and a video image acquisition system. For the auxetic foams the results suggested similar behaviour to that previously reported in the literature, with signifi cant increases in stiffness during compressive loading, and a signifi cant dependence of the Poisson’s ratio on the applied strain. Transmissibility tests, performed in accordance with the ISO 13753 procedure for antivibration glove materials, suggested a strong dependence of the transmissibility on the foam manufacturing parameters. Within the frequency range from 10 to 31.5 Hz the transmissibility was found to be greater than 1, while it was less than 1 at all frequencies greater than 31.5 Hz. The transmissibility results were similar to the mean values for 80 resilient materials tested by Koton et. al., but were higher than the fi ve best materials (not all polymeric) identifi ed by the same researchers. In this study it has been suggested that the resilient behaviour of glove isolation materials should also be evaluated in terms of the indentation characteristics. A simple, linear elastic, Finite Element simulation was therefore performed, and the indentation results suggested that auxetic foams offer a signifi cant decrease in compressive stresses with respect to conventional PU foams.