Optimal trocar placement for ergonomic intracorporeal sewing and knotting in laparoscopic hiatal surgery

BACKGROUND: Trocar placement presently is mostly empiric. Our goal was to define simple distances from bony landmarks to locate the optimal ergonomic placement of manipulation trocars for access to the lower esophagus and hiatal orifice, for suture placement, and knotting of the gastric fundus and crura. Hypothesizing that the ideal ergonomic principles of a manipulation angle of 60°, an elevation angle (e )o f 30° to 60°, and an intracorporeal/extracorporeal length ratio (I/E) of working instruments close to 1:1 are interrelated by simple trigonometric functions, the variations of each of these parameters were calculated in a dependent manner for 2 standard lengths of needle holders: 48.5 cm and 58.5 cm. RESULTS: Trocar placement can be calculated easily according to simple formulas dependent on the e, the distance from the sternoxiphoid junction to the median of the intertrocar span (d) and the vertical distance from the stenoxiphoid junction to the average distance between the apex of the hiatal orifice and the anterior aspect of the esophagus (XH’): when the eis 30°: d is XH’ 2 and when eis 45°, d is XH’/2. Likewise, when e is 30° the intertrocar span (LR) is 2XH’, half on either side of the optical axis (d), and when e is 45°, LR is XH’ 2, XH’/2 on either side of the optical axis. The most ergonomic solution is to work with an e of 40° to 45° by placing the 2 working (manipulation) trocars, between 10 and 14 cm caudad from the sternoxiphoid junction, between 10 and 12 cm on either side of the longitudinal axis corresponding to the optic-target axis. The shorter needle holder works best in this configuration because the I/E ratio will be between .8 and 1. If, however, the surgeon wants to work with an e closer to 30°, then the longer needle holder should be used, and the trocars should be placed between 20 and 21 cm from the sternoxiphoid junction, 14.5 to 15 cm on either side of the optical axis. The I/E ratio will vary between 1 and 1.1. When a 1/1 I/E ratio was prioritized, the e would be 40° and 32°, for the shorter and longer instruments, respectively. The deeper crural closure requires increasing the e by 2° and 3°, respectively. Hyperlordosis,