A 2.4 GHz 2.9 mW Zigbee RF Receiver with Current-Reusing and Function-Reused Mixing Techniques

This study presents a low-power Zigbee receiver with a current-reusing structure and function-reused mixing techniques. To reduce the overall power consumption, a low noise amplifier (LNA) and a power amplifier (PA) share the biasing current with a voltage-controlled oscillator (VCO) in the receiving (RX) mode and transmitting (TX) mode, respectively. The function-reused mixer reuses the radio frequency trans-conductance (RF gm) stage to amplify the down-converted intermediate frequency (IF) signal, obtaining a free IF gain without extra power consumption. A peak detector circuit detects the receiving signal strength and auto-adjusts the biasing current to save power when a strong signal strength is detected. Meanwhile, the peak detector helps to provide a coarse gain control as part of the auto-gain-control function. As part of the IF gain range is shared by the multiple-feedback (MFB) low-pass filter, the number of programmable-gain IF amplifier stages can be reduced, which also means a decrease in power consumption. A prototype of this wireless sensor network (WSN) receiver was designed and fabricated using the TSMC 130 nm CMOS process under a supply voltage of 1 V. The entire receiver realizes a noise figure (NF) of 3.5 dB and a receiving sensitivity of −90 dBm for the 0.25 Mbps offset quadrature phase shift keying (O-QPSK) signal with a power consumption of 2.9 mW.