SERVICE AND ULTIMATE LOAD BEHAVIOR OF BRIDGE DECK REINFORCED WITH CARBON FRP GRID

A full-scale model of a bridge deck slab isotropically reinforced with 0.3% fiber-reinforced plastic reinforcement (FRP) was tested. The 6 m long slab of 185 mm thickness had two 2 m spans and 1 m cantilevers on both sides. The slab was first loaded monotonically to crack the concrete. Then it was loaded cyclically in three stages of 4 million cycles each at a frequency of 5 Hz, with the load varying between 0 and 100 kN in the first two stages and between 0 and 125 kN in the last. Finally, it was loaded monotonically to failure. Constructability of the slab with the FRP reinforcement was found satisfactory. The cyclic load test shows that deflections and stresses are small, and the degradation indicated by increases in deflections and stresses after 4 million cycles of overloading by 25% is very small. The ultimate load capacity of the slab was at least five times the maximum wheel load of 100 kN, and the failure mode was punching shear. Long-term performance of FRP reinforcement under the combined effec...