Event Reconstruction for Atmospheric Releases Employing Urban Puff Model UDM with Stochastic Inversion Methodology

The rapid identification of contaminant plume sources and their characteristics in urban environments can greatly enhance emergency response efforts. Source identification based on downwind concentration measurements is complicated by the presence of building obstacles that can cause flow diversion and entrainment. While high-resolution computational fluid dynamics (CFD) simulations are available for predicting plume evolution in complex urban geometries, such simulations require large computational effort. We make use of an urban puff model, the Defence Science Technology Laboratory's (Dstl) Urban Dispersion Model (UDM), which employs empirically based puff splitting techniques. UDM enables rapid urban dispersion simulations by combining traditional Gaussian puff modeling with empirically deduced mixing and entrainment approximations. Here we demonstrate the preliminary reconstruction of an atmospheric release event using stochastic sampling algorithms and Bayesian inference together with the rapid UDM urban puff model based on point measurements of concentration. We consider source inversions for both a prototype isolated building and for observations and flow conditions taken during the Joint URBAN 2003 field campaign at Oklahoma City. The Markov Chain Monte Carlo (MCMC) stochastic sampling method is used to determine likely source term parameters and considers both measurement and forward model errors. It should be noted that the stochastic methodologymore » is general and can be used for time-varying release rates and flow conditions as well as nonlinear dispersion problems. The results of inversion indicate the probability of a source being at a particular location with a particular release rate. Uncertainty in observed data, or lack of sufficient data, is inherently reflected in the shape and size of the probability distribution of source term parameters. Although developed and used independently, source inversion with both UDM and a finite-element CFD code can be complementary in determining proper emergency response to an urban release. Ideally, the urban puff model is used to approximate the source location and strength. The more accurate CFD model can then be used to refine the solution.« less