R50 as a beam quality specifier for selecting stopping‐power ratios and reference depths for electron dosimetry

For electron beam reference dosimetry in radiotherapy, it is shown that by choosing the reference depth as d ref=0.6R 50−0.1 cm, where R 50 is the half‐value depth in centimeters, the Spencer–Attix water‐to‐air stopping‐power ratio at d ref is given by (L/ρ) air w =1.2534−0.1487 (R 50)0.2144. This is derived from data for (L/ρ) air w obtained from realistic Monte Carlo simulations for 24 clinical beams. The rms deviation of this expression from the Monte Carlo calculations is 0.16%, with a maximum deviation of 0.26%. This approach fully takes into account the spectral differences between real electron beams of the same R 50 and allows an absorbed‐dose calibration at a standards laboratory to be easily and accurately transferred to a reference clinical beam. Using a single paraeter to specify (L/ρ) air w , rather than the two parameters (R 50 and depth) needed when the reference depth is chosen as the depth of dose maximum, has the potential to greatly simplify electron beamdosimetry protocols and allows the use of a similar formalism for photon and electron beamdosimetry. For use in converting a depth–ionization curve into a depth–dose curve, a somewhat less accurate but general expression for (L/ρ) air w as a function of R 50 and depth is presented.