Characterization and Defect Analysis of Machined Regions in Al-SiC Metal Matrix Composites Using an Abrasive Water Jet Machining Process

Metal matrix composite (MMC) materials are increasingly used in industrial sectors such as energy, structural, aerospace, and automotive. This is due to the improvement of properties by the addition of reinforcements. Thus, it is possible to obtain properties of higher strength, better rigidity, controlled thermal expansion, and elevated wear resistance. However, due to the extreme hardness achieved during their manufacture, these composites pose a challenge to the conventional machining industry due to the rapid deterioration experienced by cutting tools. This article therefore proposes the use of an unconventional machining method that is becoming increasingly widely used: abrasive water jet cutting. This process is characterized by high production rates, absence of wear, and environmental friendliness, among other advantages. Experimental tests were carried out in order to analyze results that minimize the formation of defects in the machining of metal matrix composite consisting of aluminium matrix with silicon carbide (Al-SiC MMC). To this end, results were analyzed using Scanning Optical and Electron Microscope (SOM/SEM) techniques, the taper angle was calculated, and areas with different surface quality were detected by measuring the roughness.