Finite element analysis of various thickness occlusal stabilization splint therapy on unilateral temporomandibular joint anterior disc displacement without reduction.

Introduction Occlusal stabilization splint is the most common treatment modality for temporomandibular joint disorders, but the optimal thickness is still uncertain. This study investigated the effect of the occlusal splint with different thicknesses on the stress distribution of the temporomandibular joint. Methods Cone-beam computed tomography and magnetic resonance images were used to reconstruct the maxillofacial and disc, and the unilateral anterior disc displacement without reduction was established manually as the basic model. Occlusal splint with 5 different thickness levels (2, 3, 4, 5, and 6 mm) was added to the basic model as the study models. The displacement and stress distribution of the disc were evaluated. Results The maximum von Mises stress of the condylar cartilage was the largest on the affected side, whereas the maximum von Mises stress of the disc was the largest on the unaffected side. The disc stress on the affected side was mainly distributed on the posterior zone and the intermediate zone for the unaffected side. The maximum von Mises stress of the bilaminar region on the affected side was greater than the unaffected side. The stress of the disc and bilaminar region was the lowest on the affected side in the 2 mm model. The disc displacement on the affected side gradually increased, whereas, on the unaffected side, it fluctuated. Conclusions These results showed that occlusal stabilization splint could decrease the stress of disc and bilaminar region, and 2 mm was considered the optimal thickness for the treatment of unilateral temporomandibular joint anterior disc displacement without reduction.