In-situ fabrication of a spherical-shaped Zn-Al hydrotalcite with BiOCl and study on its enhanced photocatalytic mechanism for perfluorooctanoic acid removal performed with a response surface methodology

Abstract Perfluorooctanoic acid (PFOA), a widely used compound, is harmful to the environment and human health. In this study, a facile one pot solvothermal method of integrating BiOCl with Zn-Al hydrotalcite to form spherical-shaped BiOCl/Zn-Al hydrotalcite (B-BHZA) sample is reported. The characteristics and main factors affecting photocatalytic PFOA and photocatalytic mechanism of BiOCl/Zn-Al hydrotalcite (B-BHZA) are systematically investigated. It is found that spherical-shaped B-BHZA possesses abundant defects and a larger surface area of 64.4 m2 g−1. The factors affecting photocatalytic removal PFOA (e.g., time, pH, initial concentration and dosage) are investigated by modeling the 3D surface response. The removal rate of PFOA is over 90 % in 6 h under UV light at an optimal pH of 2, an initial concentration of 500 μg/L and a dose of dosage 0.5 g/L. The main mechanism occurs by photo-generated h+ oxidation and synergistic effects from the photocatalysis process. Though investigating the intermediates of PFOA degradation and F−, a possibility was proposed that h+ initiated the rapidly decarboxylation of PFOA. The unstable perfluoroheptyl group is formatted and further conversed to short chain perfluorocarboxylic acid. This study provides a new insight for the preparation of highly efficient photocatalysts to the treatment of halogenated compounds in UV system.