Numerical simulation research on response characteristics of surrounding rock for deep super-large section chamber under dynamic and static combined loading condition

The stability control of surrounding rock for large or super-large section chamber is a difficult technical problem in deep mining condition. Based on the in-site geological conditions of Longgu coal mine, this paper used the dynamic module of FLAC3D to study the response characteristics of deep super-large section chamber under dynamic and static combined loading condition. Results showed that under the static loading condition, the maximum vertical stress, deformation and failure range are large, where the stress concentration coefficient is 1.64. The maximum roof-to-floor and two-sides deformations are 54.6 mm and 53.1 mm, respectively. Then, under the dynamic and static combined loading condition: (1) The influence of dynamic load frequency on the two-sides is more obvious; (2) The dynamic load amplitude has the greatest influence on the stress concentration degree, and the plastic failure tends to develop to the deeper; (3) With the dynamic load source distance increase, the response of surrounding rock is gradually attenuated. On this basis, empirical equations for each dynamic load conditions were obtained by using regression analysis method, and all correlation coefficients are greater than 0.99. This research provided reference for the supporting design of deep super-large section chamber under same or similar conditions.