Droplet size development in a DISI injector fuel spray

In this work, Phase Doppler Anemometry (PDA) measurements are used to test the hypothesis that the mean droplet size in Direct Injection Spark Ignition (DISI) engine fuel spray increases with distance from the injector due to the evaporation of the smaller droplets. In order to understand the role of evaporation, two velocity components and drop size PDA measurements were performed for one plume of a DISI injector using two fuels with widely differing vapour pressures. The measurements were taken along the plume centreline at four different vertical distances from the injector tip between 20 to 50 mm. on the plume centreline to evaluate the development of droplet size distributions along the plume. Measurements are also made across the plume (perpendicular to the plume centreline) at the 30 and 50 mm locations. Measurements using PDA closer to the injector are more difficult due to the high spray density (particularly apparent at 20mm or closer to the injector). A data fitting process is suggested using joint probability distribution functions (JPDFs) to reduce the effect of statistical significance where data rates are low. This improves the description of the PDA derived drop size distribution in regions where the data validation rate is poor. It is found that the evaporation is not the main cause for droplet size increase along the plume. The most likely reason for the increase of the Sauter Mean Diameter (SMD) with distance from the injector is that the smaller droplets move away from the plume centreline through turbulent diffusion at a higher rate compared to larger droplets. Higher axial momentum of the larger droplets reduces their response to turbulent velocity fluctuations and hence their path-lines are less prone to stray from their initial trajectory.