Optimization of procedures for separation of motile and nonmotile bull and rabbit spermatozoa with bovine serum albumin gradients

The effect of equipment design, separatory media, and time and temperature of separation were studied. Discontinuous 4%/10% bovine serum albumin (BSA) gradients were used to isolate highly motile spermatozoa in rabbit and bull semen. For all conditions tested, motility of spermatozoa collected from the 4% BSA gradient layer (top) was less than or equal to the motility of the unseparated controls. Fractions collected from the 10% BSA gradient layer contained highly motile spermatozoa. In experiment 1, washed bull spermatozoa were diluted with phosphate-buffered saline (PBS) containing 2% BSA or 4% BSA before being fractionated on BSA columns contained in test tubes. Inclusion of BSA in PBS tended to reduce loss of motility during washing, but the proportion of sperm recovered was highest in PBS. In experiment 2, motility and recovery of buck spermatozoa collected from the 10% BSA gradient region tended to be higher when fractionation temperature was 30°C as compared to 35°C, and motility was significantly higher when incubation time was 30 min as compared to 1 hr. The proportion of sperm recovered was unaffected by incubation time. In experiments 1 and 2, 41 of 48 separations resulted in at least one fraction containing spermatozoa with motility greater than or equal to 90%. In the third experiment, the surface area on which bull and buck spermatozoa were layered was increased by forming the 4%/10% BSA gradients in conical supports. Separation of sperm on conically shaped columns was not as effective as on cylinders. The use of cylinders to support the BSA gradients and a separation time of 30 min at 30°C is recommended.