Molecular imprinting of hemispherical pore-structured thin films via colloidal lithography for gaseous formaldehyde Gravimetric sensing

Abstract In this study, formaldehyde (HCHO)-imprinted hemispherical pore-patterned thin films, consisting of poly(2-(trifluoromethyl)acrylic acid–co–ethylene glycol dimethacrylate–co–styrene) (poly(TFMAA–co–EGDMA–co–ST)), were fabricated using the design of molecularly imprinted polymers (MIPs) and a subsequent lithographic micro/nanoimprinting method to amplify HCHO sensing signals in quartz crystal microbalance (QCM) sensors. Its molecular imprinting condition was optimized by controlling the added amount of a ST monomer in a MIP precursor solution. From the resonant frequency change with respect to HCHO adsorption, the imprinting factor of the porous MIP film was calculated to have a value of 2.38 and the sensitivity (0.132 mg g−1 ppm−1) of the porous MIP film exhibited markedly improved characteristics with respect to the porous non-imprinted polymer (NIP) film (0.05 mg g−1 ppm−1). The selectivity of the MIP-QCM sensors for the detection of HCHO was examined in the presence of other analogous toxic gases such as hydrogen chloride and hydrogen fluoride. The HCHO-absorbed porous MIP film had higher selective features with selectivity coefficients (k* ≈ 3.83 (HCl) and 4.46 (HF)) than porous NIP films (k* ≈ 1.53 (HCl) and 2.20 (HF)). Moreover, the relative selectivity of the porous MIP film appeared to be 2.03–2.5, which was higher than those of the planar MIP film (1.70–1.73).