Mechanical study of polycaprolactone-hydroxyapatite porous scaffolds created by porogen-based solid freeform fabrication method.
2014
Materials and Methods: Polycaprolactone (PcL) and polycaprolactone-hydroxyapatite (PcL-HA) scaffolds with 600-μm pore size were fabricated by drop-on-demand printing (ddP) structured porogen method followed with injection molding. specimens with special dimensions of 4.2×4.2×5.4 mm3 and 6.6×6.6×13.8 mm3 were designed and fabricated for compression and tensile tests, respectively. the mechanical study was performed on both solid and porous PcL and PcL-HA samples. the effect on mechanical properties of the HA content ratio in PcL-HA composites was investigated. Results: Porous scaffold made of 80/20 PcL-HA composite had an ultimate compressive strength of 3.7±0.2 MPa and compression modulus of 61.4±3.4 MPa, which is in the range of reported trabecular bone’s compressive strength. Increasing the concentration of HA in the composites raised compressive properties and stiffness significantly (P<0.05), which demonstrates that PcL-HA composites have the potential for application in bone regeneration. tensile test of solid PcL and PcL-HA composites showed that the ultimate tensile strength and tensile modulus increased with increases of the concentration of HA in the composites. the tensile test was also conducted on PcL porous scaffold; the result indicated that the scaffold was slightly softer and weaker in tension compared with compression. Conclusions: combining compression and tensile test results, our study may guide the possible application of these biomaterials in bone tissue engineering and support further development of microstructure-based models of scaffold mechanical properties.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
43
References
14
Citations
NaN
KQI