Experimental study of the compression behavior of mask image projection based on stereolithography manufactured parts

The article presents the results of a series of compression tests on samples manufactured by means of the mask image projection based on stereolithography additive manufacturing technique (MIP-SL). Recent studies demonstrate the orthotropic nature of the MIP-SL materials. A research is initiated by the authors to attempt to predict the degree of anisotropy from the manufacturing parameters of the MIP-SL parts. The article focuses mainly on the development of the experimental compression tests of the first stage of the research. Special attention is paid to the four methods used to obtain the stress-strain curve of the material: strain gages, 2D Digital Image Correlation, extensometer measurements and crosshead displacement measurements. The article shows the advantages and limitations of each method. Finally, the anisotropic behaviour is verified and a testing procedure is set to obtain the constitutive parameters of the MIP-SL tested materials