Surface texturing by pulsed Nd:YAG laser

Abstract Introducing specific textures on a tribological surface can contribute to friction reduction in sliding contacts. In the present paper, a pulsed Nd:YAG laser emitting at 1064 nm, was used against 100Cr6 steel samples in order to produce well-defined surface micro-pores, which can act as lubricant reservoirs, micro-hydrodynamic bearings as well as traps for wear debris. Due to the high flexibility of the laser system, structural features such as shape, size, density and depth can be varied easily by changing the laser parameters. To optimize the parameters of the laser surface texturing process, an investigation was performed using different pulse numbers, various pulse energies and two different modes (single- and multi-mode). The microtextures were characterized with optical microscopy, scanning electron microscopy (SEM) and by topography techniques. The relationship between the laser processing parameters and qualitative and quantitative profile of the micro-pores was studied. Tribological testing of laser textured surfaces was performed in a low frequency–long displacement reciprocating sliding wear tester under boundary lubrication and results compared to un-textured case. Tribological comparison of textured, textured and lapped, and untextured surfaces shows only minimal influence of texturing for contact conditions investigated.