Recovery of copper through decontamination of synthetic solutions using modified barks
1997
Decontamination of synthetic acetate, chloride, nitrate, and sulfate solutions containing 10, 100, 1,000, 10,000, and 50,000 ppm of copper using chemically treated barks has been studied. Metal percentage removal from solutions depends on the pH, the initial concentration, and, to some extent, the anion. It varies from 40 through 99 pct of the initial metallic ion’s content in the solution. The average retention capacity of the treated bark is about 43 mg of Cu/g of dry modified bark (0.68 mmole/g of dry bark). Extraction of copper cations from the saturated modified bark was made possible with dilute acid. Regeneration of bark for reuse as an ion exchanger was possible. Bark loaded with copper was analyzed by scanning electron microscopy (SEM) and infrared (IR) spectroscopy. Copper was uniformly distributed in the bulk of the bark. No copper segregation was observed. It seems that copper was bound to the acidic (phenolic) sites of the bark. Anions were not detected on the copper-loaded bark with either SEM electron probe microanalysis or IR spectroscopy. Incineration of the bark loaded with copper resulted in ashes containing about 77 pct of copper oxides, while pyrolysis of the same sample led to ashes containing 10 pct of metallic copper and about 85 pct carbon.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
21
References
104
Citations
NaN
KQI