X-pinch dynamics close to the time of X-ray burst emission, and X-pinch bright spot location using X-ray backlighting
1999
Summary form only given, as follows. In the final few ns before the moment of the X-ray burst emission near the cross point of the two wires in an X-pinch, an on-axis Z-pinch forms, the dynamics of which have been studied using direct (point projection) X-ray backlighting. The rapid collapse of the Z-pinch results in a gap in the observable mass distribution, which we refer to as a minidiode. Two Mo X-pinches were placed in parallel between the output electrodes of the 450 kA, 100 ns XP pulser at Cornell University. The <0.5 ns radiation burst from each of the two X-pinches was used to generate a magnified X-ray backlighter image on film of the other one. The size of the X-ray source is sufficiently small that the spatial resolution in the images is close to 1 /spl mu/m. Using different wire sizes in the two X-pinches yields images separated in time by 4-20 ns; using the same wire size yields images separated in time by 0.5-2 ns. Therefore, the dynamics of the rapid collapse of the on-axis Z-pinch in conjunction with minidiode formation, and the break-up of that Z-pinch just as the bright X-ray spots develop can be studied using the successive images from 4 ns before X-ray burst emission, through the moment of burst emission, to a few ns after burst emission. By superimposing images generated by both X-pinches of a grid of fine wires on the same films as the X-pinch images, it has been possible to locate the position of the bright X-ray emission point(s) in the Z-pinch/minidiode region to within 10 /spl mu/m. The emission points are usually within 100 pm of the original cross point of the two wires, near the ends of the collapsing Z-pinch. Calibrated density measurements have been made with W X-pinches by including a W step wedge in the film pack.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
0
References
0
Citations
NaN
KQI