VERTEBROPLASTY ENHANCES LOAD-BEARING BY A FRACTURED VERTEBRAL BODY

Introduction : Cement augmentation of osteoporotic vertebral fractures by vertebroplasty can alleviate pain, although the mechanism remains unknown. We hypothesise that vertebral fracture reduces loading by the vertebral body, and that vertebroplasty reverses this effect. Methods : Nineteen thoracolumbar motion segments (64 – 90 yrs) were used. Specimens were compressed at 1.5kN in moderate flexion and extension while intradis-cal stress profiles were obtained by pulling a miniature pressure transducer along the mid-sagittal diameter of the disc (1). Vertebral fracture was induced by compressive overload in moderate flexion. Vertebroplasty was then performed by injecting polymethylmethacry-late cement into the anterior vertebral body. Stress profiles were repeated after fracture, and after vertebroplasty. Stress concentration in the annulus was calculated by subtracting the nuclear pressure from the maximum stress in the annulus. Neural arch compressive load was obtained by subtracting the disc compressive force, calculated by integrating intradiscal stress over area, from the applied 1.5kN (1). Results : Fracture increased the stress concentration in the annulus from 0.21 to 0.58MPa in flexion (p Discussion : Vertebral fracture reduces load-bearing by the vertebral body, and increased compressive loading of the neural arch. Vertebroplasty goes some way to reversing these effects, and significantly decreased stress concentration in the annulus and loading of the neural arch in flexion. This could contribute to pain relief in patients undergoing this procedure.