Effect of fuel choice on nanoparticle emission factors in LPG-gasoline bi-fuel vehicles

Nanoparticle and gas-phase emission factors are presented for a liquefied petroleum gas (LPG) passenger vehicle and are compared to gasoline operation. A bi-fuel LPG-gasoline vehicle certified for use on either fuel was used as the test vehicle so that a direct comparison of the emissions could be made based on fuel choice. These values were considered along with previous studies to determine the relative change in particulate emissions due to fuel choice over a wide range of vehicles and operating conditions. The vehicle examined in this study was tested on a chassis dynamometer for both steadystate and transient conditions. Transient test cycles included the US FTP72 driving cycle, Japanese driving cycle and modified Indian driving cycle while steady-state tests were done at vehicle speeds ranging from 10–90 km/hr in various transmission gears. Exhaust particle size distributions were measured in real-time using a differential mobility spectrometer (DMS50), and particle number and particle mass emission factors were calculated. For both fuels, the majority of the particles ranged from 5 to 160 nm in terms of particle diameter, with typically more than 85% of the particles in the nucleation mode (between 5–50 nm). In most cases, the vehicle produced a greater fraction of larger (accumulation mode) particles when fuelled on LPG. Using the data in the literature as well as the data in the current study, gasoline fuel produces 4.6 times more particles in terms of number and 2.1 times more particles in terms of mass.