Interaction between clay-based sealing components and crystalline host rock
2011
Abstract The results of hydraulic–mechanical (H–M) numerical simulation of a shaft seal installed at a fracture zone (FZ) in a crystalline host rock using the finite element method are presented. The primary function of a shaft seal is to limit short-circuiting of the groundwater flow regime via the shaft in a deep geological repository. Two different stages of system evolution were considered in this numerical modelling. Stage 1 simulates the groundwater flow into an open shaft, prior to seal installation. Stage 2 simulates the groundwater flow into the shaft seal after seal installation. Four different cases were completed to: (i) evaluate H–M response due to the interaction between clay-based sealing material and crystalline host rock in the shaft seal structure; (ii) quantify the effect of the different times between the completion of the shaft excavation and the completion of shaft seal installation on the H–M response; and (iii) define the potential effects of different sealing material configurations. Shaft sealing materials include the bentonite–sand mixture (BSM), dense backfill (DBF), and concrete plug (CP). The BSM has greater swelling capacity and lower hydraulic conductivity ( K ) than the DBF. The results of these analyses show that the decrease of the pore water pressure is concentrated along the fracture zone (FZ), which has the greatest K . As the time increases, the greatest decrease in pore water pressure is found around the FZ. Following FZ isolation and the subsequent filling of the shaft with water as it floods, the pore water pressure profile tends to recover back to the initial conditions prior to shaft excavation. The majority of the fluids that ultimately saturate the centre of the shaft seal flow radially inwards from the FZ. The time between the completion of the shaft excavation and the completion of shaft seal installation has a significant effect on the saturation time. A shorter time can reduce the saturation time. Since most of the inflow comes from the FZ, application of the BSM for extended distances above and below the FZ does not significantly affect the saturation time of the volume adjacent to the FZ. The application of BSM near the FZ rather than a low swelling capacity, more permeable filling material is very significant. This study assumed a perfect contact between seal materials and host rock. Limited to the assumptions used in this study, use of BSM near the FZ was found to increase the time before the centre of the shaft seal became fully saturated from between 4 and 30 years (when the DBF is used) to between 90 and 100 years (when the BSM is used).
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
8
References
2
Citations
NaN
KQI