Oxygen Transfer Capacity of Pseudobrookite Particles Derived from Ilmenite Mineral (x wt.%CuO/y wt.%red Mud-z wt.%ilmenite)

: The minerals have a somewhat slower than other transition metals at critical reduction rates in their ability to deliver oxygen. Thus, single minerals alone do not exhibit a higher oxygen transfer capacity than metal oxide oxygen carriers. In this study, we try to solve the problem of single mineral ilmenite (FeTiO₃) by combining it with Fe-based red mud and Cu oxide. When the ilmenite was used without calcination, the CH₄-CO/air redox cycle showed rapid decayed. However, when ilmenite was calcined, the CH4-CO/air redox cycle became stable, and the oxygen transfer rate increased to 4.2%. This is because the FeTiO₃ structure was converted to the pseudobrookite (Fe₂TiO5) structure through the calcination process. That is, the Fe2+ ion in the ilmenite structure was converted into an Fe3+ ion. When 30 wt.% of red mud was added to the Fe ion, it reacted with the rutile-type titania mixed with pseudobrookite-typed Fe₂TiO5, producing an almost perfect pseudobrookite crystal. This resulted in a slight increase in the capacity of oxygen transfer to 4.9%. When 15 wt.% of Cu oxide was added, the oxygen transfer capacity increased to 6.0%. This performance was indicated by the cyclic voltammetry curve that remained constant even after 200 cycles. Here, we argue that if low-cost minerals as a base material are used in appropriate amounts, the production of a lowest-cost oxygen carrier can be achieved.