Wideband coplanar waveguide-to-rectangular waveguide transition using fin-line taper
2005
This letter introduces a new wideband coplanar waveguide-to-rectangular waveguide transition. The transition uses a uniplanar circuit in line with the waveguide, which eases the design and fabrication. The design does not require airbridges. Simulations and measurements of X-band (8.2-12.4 GHz) transitions based on both a low- and high-permittivity material (/spl epsiv//sub r/= 2.33 and 10.8) show that the transition works fine over the full frequency band. For /spl epsiv//sub r/= 2.33 the measured return and insertion loss of a back-to-back transition are more than 16 dB and less than 0.4dB, respectively. The corresponding values for /spl epsiv//sub r/= 10.8 are more than 10 dB and less than 1.0 dB, respectively, over 90% of the frequency band. The measured insertion loss values indicate losses of less than 0.14 dB and 0.36 dB at the center frequency for a single transition on a substrate with /spl epsiv//sub r/= 2.33 and 10.8, respectively.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
13
References
37
Citations
NaN
KQI