Thickness-Dependent Photo-Aligned Thin-Film Morphologies of a Block Copolymer Containing an Azobenzene-Based Liquid Crystalline Polymer and a Poly(ionic liquid).

Photo-induced alignment of the thin-film morphologies of azobenzene-containing block copolymers (BCPs) is an effective method to obtain a uniaxial pattern of nanocylinders. Although film thickness is an important factor affecting the self-assembly of BCP thin films, the influence of film thickness on the photo-induced alignment of BCP thin-film morphology has never been systematically studied. Herein, we report the thickness-dependent photo-aligned film morphologies of the BCP containing an azobenzene-based liquid crystalline polymer and a poly(ionic liquid) (PIL), with a perfect uniaxial pattern of PIL nanocylinders. For films aligned with the unpolarized light (UPL), the out-of-plane PIL nanocylinders can be obtained in the film with a thickness of only 1L0 (∼30 nm, where L0 is the layer spacing of the hexagonally packed cylinder array), which is far lower than the thickness (more than 4L0) of the thermally annealed film needed to obtain the same morphology. This change is attributed to the orientation effect of UPL on azobenzene mesogens that suppresses the excluded volume effect. For the films aligned with linearly polarized light (LPL), to take advantage of the excluded volume effect to obtain the planar orientation of azobenzene mesogens, the thickness should be controlled to be no more than 3L0 to achieve an in-plane uniaxial alignment of PIL nanocylinders. The above relationship between the morphology and thickness of photo-aligned film eliminates the obstacles encountered in preparing films with well-ordered photo-aligned morphologies.