Russian scatterometer: discussion of the concept and the numerical simulation of wind field retrieval

Orbital scatterometry is briefly overviewed and its trends are indicated. Two scatterometer concepts are currently considered for trade-offs: with fixed and rotating antenna systems. The concept with a rotating antenna system was selected and SeaWinds was chosen as the prototype for the first Russian scatterometer. The scatterometer concept was then further developed and instead of two pencil beams, a fan-beam antenna was proposed about 1° × 6°. The fan-beam antenna allows successive measurements for horizontal and vertical polarization in each wind vector cell WVC. This increases the number of observations of the WVC at different incidence and azimuth angles during flight. The scatterometer parameters required to implement the proposed measurement geometry for an orbit altitude of 650 km and a swath width of 1525 km are discussed. A numerical scatterometer model that accounts for both the specifications and the observation geometry is developed. The scatterometer performance, with subsequent formation of a swath and splitting into WVCs, is simulated. The procedure of wind vector retrieval includes two stages: 1 determining wind speed and wind direction in a single WVC; and 2 using the information from adjacent WVCs to correct wind direction. It is shown that the accuracy of wind direction retrieval by a WVC can be increased by simultaneous radar cross-section RCS measurements at vertical and horizontal polarization. The basic error in determining wind direction is due to a 180° wind direction ambiguity caused by the form of RCS azimuth dependence. Two-dimensional median filtering is commonly employed in scatterometry to increase the accuracy of wind direction retrieval. In this study, two-dimensional angular median filtering was employed and it is shown that the error in wind direction retrieval significantly decreased. The results of the research indicate that wind field can be retrieved by the new scatterometer with the level of precision required.