Assessing model calibration adequacy via global optimisation

An assessment of the application of varying levels of optimisation on model simulation performance and parameter identification was done using the genetic algorithm (GA) and a 10-parameter version of the MODHYDROLOG rainfall-runoff model, Four levels of optimisation were obtained through the use of two GA formulations, the traditional and an improved GA, and by varying the optimisation parameters with each formulation. Sixteen years of data from a 27 km 2 Australian catchment was used. With each level, ten randomly initialised optimisation runs were made. The differences in simulation performance quantified by the coefficient of efficiency, bias, absolute deviation and a residual mass curve coefficient were notconsiderable although the performance improved as the level of optimisation effort increased. Superior parameter identification, and consequently a better detection of parameter correlations was achieved with the higher optimisation levels. Based on the objective function values, the highest level of optimisation practically located the global optimum in all the ten runs. The second level achieved this in nine of the ten runs whi le the lower two levels did not locate the global optimum in any of the ten runs. It is proposed that the systematic verification of the adequacy of optimisation should be an integral part of model calibration exercises. The form of verification should depend on the specific problem at hand.