Fabrication and Characterization of Silicon (100) Membranes for a Multi-beam Superconducting Heterodyne Receiver

We fabricated silicon (100) membranes of 3 mm in diameter on the surface of silicon-on-insulator (SOI) substrates and investigated the characteristics of the membranes. The handle layer of one SOI substrate was etched using deep reactive ion etching process with the buried oxide (BOX) layer that remained together with the device layer. The BOX layer of the other SOI substrate was removed using C4F8-based plasma etching after the handle layer etching. The surfaces of both silicon (100) membranes were observed using the scanning white light interferometer system at room temperature. Both silicon (100) membranes have dome-like deformations. The silicon (100) membranes are effectively flattened by etching the BOX layer under the device layer. Both silicon (100) membranes were cooled from room temperature to 4 K by a Gifford–McMahon refrigerator. Wrinkles appeared on the surfaces of both silicon (100) membranes when the temperature dropped to about 200 K. However, the wrinkles disappeared below about 180 K. This phenomenon indicates the wrinkles at low temperature would depend on the properties of the silicon (100) of the device layers and independent of the properties of the BOX layers under the silicon (100) membranes.