An experimental investigation of oblique cutting mechanics

ABSTRACTIn this study, an experimental investigation of oblique cutting process is presented for titanium alloy Ti-6Al-4V, AISI 4340, and Al 7075. Important process parameters such as shear angle, friction angle, shear stress, and chip flow angle are analyzed. Transformation of the data from the orthogonal cutting test results to oblique cutting process is applied, and the results are compared with actual oblique cutting tests. Effects of hone radius on cutting forces and flank contact length are also investigated. It is observed that the shear angle, friction angle, and shear stress in oblique cutting have the same trend with the ones obtained from the orthogonal cutting tests. The transformed oblique force coefficients from orthogonal tests have about 10% discrepancy in the feed and tangential directions. For the chip flow angle, the predictions based on kinematic and force balance results yield better results than Stabler's chip flow law. Finally, it is shown that the method of oblique transformation a...