Effects of Lubrication Mode on Friction and Heat Partition Coefficients at the Tool–Work Material Interface in Machining

The quantification of friction coefficient along the tool–work material interface in machining remains an issue in tribology. This article aims at identifying the evolution of friction coefficient for a large range of sliding velocity during the machining of an AISI 4140 steel (290 HB) with a TiN-coated carbide tool. The influence of various lubricants (straight oil or emulsion) and lubrication modes (flow or mist) is investigated and compared to a dry sliding situation (dry machining). It has been shown that, in dry machining, the friction coefficient decreases with the sliding velocity until reaching a lower limit around 0.2. On the contrary, the presence of a straight oil significantly decreases friction coefficients to a value around 0.1. Emulsion enables a significant decrease of friction coefficient to around 0.2 for low sliding velocities, whereas its action is absent for higher sliding velocities. Oil mist exhibits an intermediate behavior. Finally, it has been shown that all kinds of lubrication ...