Experimental Investigation of Triggered Vacuum Arc Behavior Under Different Composite Structural Contacts
2019
Using magnetic fields to control the vacuum arc is a major way to improve the breaking capacity of vacuum interrupters. Besides the single transverse magnetic field (TMF) and single axial magnetic field (AMF), new type of TMF-AMF contact and TMF-TMF contact structures have been put forward to control the vacuum arc in recent years. In this paper, three different structural contacts are used in the experiments. The arc evolution was captured by an high-speed digital video camera, and at the same time, the arc current and arc voltage wave were recorded. The experiment was conducted under current ranging from 5 to 20 kA (root mean square) and 10 mm of gap distance. There are 12 current shots performed on one contact design. There are four current levels in the experiment which are 5, 10, 15, and 20 kA, and three tests are taken for each current level. The results showed that for TMF-AMF contacts, under low current (I = 5 or 10 kA), the arcs of the two kinds of contacts both kept diffused and rotating. Under high current (I = 20 kA), the arc of the TMF-AMF contact with six slots was constricted and rotated on the plate, and the melting was uniform and slight. As for the eight-slot contacts, the arc was constricted but did not rotate which resulted in significant melting in the local region. As for TMF-TMF contacts, the result is similar under low current, while the arc was constricted and rotated quickly on the inner plate under high current. The simulation results show that when the arc core is located on the outer plate; the total Lorentz force is near zero. When the arc core is located on the inner plate, the direction of total force is counterclockwise.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
0
References
0
Citations
NaN
KQI