PM10 Dispersion Modeling by Means of CFD 3D and Eulerian–Lagrangian Models: Analysis and Comparison with Experiments☆
2016
Abstract This research deals with the analysis of the dispersion of PM 10 by using fluid-dynamic simulation framework. Firstly, an experimental campaign was made in a wind tunnel. A cylindrical emitter of PM 10 was characterized in terms of PM 10 mass flow rate and outlet velocity. It was positioned in the wind tunnel chamber where several sensors were also placed downwind. The use of different sensor configurations allowed the evaluation of the PM 10 concentrations in several locations. The experimental campaign was reproduced in ANSYS-Fluent, by recreating in Design-Model, a 3D geometries of the test case. Different calculation grids were tested in order to find the proper balance between computing time and accuracy. The CFD 3D model was based on the Eulerian approach for the continuous phase and Lagrangian approach for the dispersion phase setting the DPM for the evaluation and dispersion of particulate matters. The turbulence was solved by using a k-ɛ RANS approach and a quite advanced unsteady DES model. Several simulations were carried out by varying the flow inlet velocities in configurations with and without obstacles. The results obtained from the post-processing phase were then compared with the experimental campaign. With obstacles a PM concentration increment is observed at all imposed air velocity because of recirculation phenomena generated around the obstacles.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
13
References
13
Citations
NaN
KQI