Miniaturized InSb photovoltaic infrared sensor operating at room temperature
2006
This paper reports the development of a novel InSb photovoltaic infrared sensor (InSb PVS) operating at room temperature. The InSb PVS consists of an InSb p + /p - /n + structure grown on semi-insulating GaAs (100) substrate, with a p + Al 0.17 In 0.83 Sb barrier layer between p + and p - layers to reduce diffusion of photo-excited electrons. Photodiodes were fabricated by wet etching process and, using a 500K blackbody, we obtained D* of 2.8x10 8 cmHz 1/2 /W and R V of 1.9 kV/W at room temperature. S/N was improved with the serial connection of 700 photodiodes patterned on a 600x600 μm 2 chip. Increasing the number (N) of connected photodiodes, S/N ratio was improved by a factor of N 1/2 . RV was constant for signals ranging from DC to 500Hz. From spectral response measurements a cut-off wavelength of 6.8 μm was obtained. The InSb PVS was flip-chip bonded on a pre-amplifier IC, allowing the shortest connection between the InSb PVS and the pre-amplifier, making the system immune to electromagnetic noise. The system was finally encapsulated by a Dual Flat Non-leaded (DFN) package with a window, which exposes the backside of the GaAs substrate allowing the infrared light incidence. The device external sizes are 2.2 mm x 2.7 mm x 0.7 mm and to our knowledge is the smallest uncooled sensor for the middle-infrared range reported until now.
Keywords:
- Correction
- Source
- Cite
- Save
- Machine Reading By IdeaReader
0
References
6
Citations
NaN
KQI