IDENTIFIKASI DISTRIBUSI LAPISAN RESERVOARBERDASARKAN PARAMETER PETROFISIKA DANINVERSI AI MODEL BASED PADA FORMASI PLOVERLAPANGAN “AMAG” CEKUNGAN BONAPARTETIMOR LESTEOleh :
2016
ABSTRAK
Penelitian dilakukan pada Formasi Plover lapangan “AMAG” yang
terletak di Cekungan Bonaparte. Penelitian ini dilakukan dengan tujuan untuk
mengetahui zona potensial dengan melakukan analisa petrofisika dan menentukan
nilai AI pada zona reservoar berdasarkan hasil inversi, serta mengetahui
persebaran reservoar berdasarkan slicing impedansi akustik.
Penelitian ini mengunakan data seismik dan data sumur yang terdiri atas
data 2D post stack 72 lines, data sumur yakni sumur Makikit dan sumur Kurita,
serta data Checkshoot. Parameter petrofisika yang dianalisa dalam penelitian ini
adalah penentuan porositas efektif dengan metode density porosity dan saturasi
air (Sw) dengan metode Indonesian dari kedua sumur. Sedangkan pada analisa
data seismik metode yang digunakan pada penelitian ini adalah metode seismik
inversi model based, dimana akan menghasilkan suatu model inversi, berupa
model inversi impedansi akustik. Parameter yang diperoleh dari analisa
petrofisika pada kedua sumur dipakai sebagai kontrol terhadap model yang
dihasilkan dari data seismik. Adapun penelitian ini dilakukan slicing impedansi
akustik.
Berdasarkan hasil analisa petrofisika yang diperoleh dari kedua sumur
yaitu terdapatnya zona potensial pada sumur Makikit pada kedalaman 3289 –
3309 m dengan nilai porositas efektif rata-rata 4,8 % dan nilai Sw rata-rata 37 %
dan nilai Rw 0,1 ohm m, dan nilai petrofisika yang diperoleh dari sumur Kurita
pada kedalaman 3256 – 3335 m memiliki nilai porositas efektif rata-rata 5,3 %
dan nilai Sw rata-rata 90 % dan nilai Rw 0,03 ohm m, sedangkan berdasarkan
hasil Inversi yang diperoleh pada lapangan “AMAG” dengan zona reservoar yang
berupa pasir, memiliki nilai impendansi akustik yang tinggi dengan kisaran nilai
antara 11500-12900 (m/s)*(gr/cc) dimana pada slicing AI yang diperoleh
menunjukan persebaran nilai AI yang tinggi dijadikan zona prospek berada pada
3050 - 3250 ms pada peta Time structure, merupakan reservoar channel yang
ABSTRACT
The study was conducted in the Plover Formation "AMAG" field located
in Bonaparte Basin. This study was conducted to determine potential zones with
petrophysical analysis and determine the value of AI in the reservoir zones based
on the results of the inversion, as well as knowing the distribution of reservoir
based slicing acoustic impedance.
This study uses seismic data and well data consisting of 2D data post stack
72 lines, well data consists of Makikit well and Kurita well, and Checkshoot data.
Petrophysical parameters were analyzed in this study to determine the effective
porosity using density porosity method and Indonesian method to determine water
saturation (Sw) of both wells. While the seismic data analysis methods used in
this study is a model-based method of seismic inversion, which will produce a
model inversion, a model of acoustic impedance inversion. Parameters obtained
from petrophysical analysis on both wells used as control of the model generated
from seismic data. The study was conducted slicing acoustic impedance.
Based on petrophysical analysis results obtained from the two wells is the
presence of a potential zone at Makikit wells at a depth of 3289 - 3309 m with the
value of the average effective porosity of 4.8 % and an average value of Sw 37 %
and with the an average value of Rw 0.1 ohm m, and petrophysical values
obtained from Kurita wells at a depth of 3256 - 3335 m has a value of average
effective porosity of 5.3 % and an average value of Sw 90 % and with the an
average value of Rw 0.03 ohm m. while based on the inversion results obtained in
the “AMAG” field the reservoir zones in the form of sand, has a high acoustic
impedance value with a range of values between 11,500 to 12,900 (m / s) * (g /
cc) where the slicing AI obtained show high scatter of AI are zoned prospects in
3050-3250 ms on a map Time structure, is a channel that is zoned reservoir
potential prospects as an reservoir.
Keywords : Effective Porosity, Sw, Rw, inversion, acoustic impedance.
Keywords:
- Correction
- Cite
- Save
- Machine Reading By IdeaReader
0
References
0
Citations
NaN
KQI